Eaton 60 kVA Betriebsanweisung PDF herunterladen (Seite 69)

Standard System Installation

Eaton BladeUPS 5.1 kVA to 60 kVA (N+1) User’s Guide 164201649—Rev 9 www.eaton.com/powerquality 63

10. If installing optional EBM(s), see “EBM Installation” on page 43. 

Otherwise, continue to “UPS Setup” on page 63.

UPS Setup

The UPS comes with all hardware required for installation in a standard EIA or JIS seismic rack-mount

configuration with square and round mounting holes. The rail assemblies adjust to mount in 48-cm (19-inch)

racks with front to rear rail distances from 61

to 76 cm (24 to 30 inches) deep.

Checking the UPS Accessories

Verify that the following items are included with the UPS:

UPS front cover

Communication terminal block connectors:

- (3) two-pin connectors

- (2) two-pin connectors with jumpers

- (1) three-pin connector

(2) wire saddles

Communication cable (DB-9/DB-9)

Documentation and software tools

- Software Suite CD

- BladeUPS: Documents, Firmware, and Installation Video CD

- This user’s guide

Mounting brackets and fasteners (if not already installed):

- (2) mounting brackets

- (8) 6-32 flat-head screws

Rails and fasteners:

- (2) sliding rail assemblies (left and right)

- (2) rear hold-down brackets

- (16) M5 machine screws

- (8) M5 clip nuts for racks with round holes

- (8) M5 cage nuts for racks with square holes

- (8) M6 hex nuts with integrated washers

Parallel system only. Verify that the following items are included with each Powerware Hot Sync CAN Bridge

Card

CAN Bridge Card cable with (2) RJ-45 connectors

Redundant signal cable with (2) two-position terminal block connectors

(2) blue terminating plugs

NOTE If you are installing the EBM with a new UPS at the same time, use the UPS user’s

guide to install both the UPS and the EBM.

NOTE Mounting rails are required for each individual cabinet.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 144 145

Keine Kommentare

Eaton 60 kVA Betriebsanweisung Seite 69